Hi people.
I need help with blackcat i bought a few years ago from TCNISO, it is a pcb 1.3. The new version of flashcat 330 driver gives me code 10 in all windows from xp up to 7 x86/x64. so i use blackcat 247.RC12 drivers which install the board fine and blackcat 247 detects the device and firmware on the device fine, but since i want to update the hex in the board and i need AVR firmware tab for that, it is there where my problem is, the AVR tab won’t show up so I cannot update the firmware, the blackcat software tells me that I have firmware 4.01 and that I should upgrade AVR firmware to 6.00 or newer, but like I said the AVR tab won’t show up so I can't update. I tried all 4 possible switch placements, still no AVR tab. Any ideas I can use to make AVR tab show up to update the device? Please advice and thx.
I need help with blackcat i bought a few years ago from TCNISO, it is a pcb 1.3. The new version of flashcat 330 driver gives me code 10 in all windows from xp up to 7 x86/x64. so i use blackcat 247.RC12 drivers which install the board fine and blackcat 247 detects the device and firmware on the device fine, but since i want to update the hex in the board and i need AVR firmware tab for that, it is there where my problem is, the AVR tab won’t show up so I cannot update the firmware, the blackcat software tells me that I have firmware 4.01 and that I should upgrade AVR firmware to 6.00 or newer, but like I said the AVR tab won’t show up so I can't update. I tried all 4 possible switch placements, still no AVR tab. Any ideas I can use to make AVR tab show up to update the device? Please advice and thx.