• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

Blackcat USB Xport v2.0 factory firmware

zerosparks

New Member
Does anyone have the original flash that comes shipped on the Xport 2.0?
Also is there firmware that supports JTAG on XPORT? Seems I lost JTAG option when I updated the flash on my XPORT.
Many thanks, AtoD
 
XPORT does not support JTAG

checkbox.png
Multi-voltage I/O devices
3.3v and 5v memory devices​
checkbox.png
Parallel / Multi-Purpose Flash memory
Series 28 and 29​
checkbox.png
NAND memory devices
Supports all SLC x8 NAND devices​
checkbox.png
Supports high-density NOR
Supports addresses up to A27​
checkbox.png
Series 25/26 SPI Flash MemorySPI / SQI devices supported
checkbox.png
I2C and TWI EEPROM devicesAll 24Cxx supported
 
Hi D3m0n,
Thanks for the reply. The reason I asked about XPORT and JTAG is that I am presented with JTAG option in the Flashcat software.
I have my XPORT flashed with FCUSB.XPORT.5.18.PCB2.hex and the XPORT is detected and message "FlashcatUSB XPORT ready for operation in JTAG mode" is now displayed at the bottom. Also in the manual JTAG is listed as supported by XPORT?
IF JTAG is not actually supported I'd like to use the XPORT in I2C mode but I am not given this option? (See last screen shot)
This all has me very confused. Pehaps I don't have my XPORT configured correctly? What firmware is recommended the XPORT 2.0?
Any help appreciated,
Zerosparks

1608655182914.png


1608654622660.png
1608654665098.png
1608655640395.png
 

Attachments

  • 1608654544327.png
    1608654544327.png
    20.9 KB · Views: 7
Back
Top