FlashcatUSB Classic v2.2 help

[BebokingPR]

hello my good people good day I have a problem is that I buy the flashcatusb Classic and I have tried with several versions and firmware and I do not recognize the SB5100 and SB5101 modems that I must do that type of firmware and program use someone to help me in this problem and I have Windows 10 it is already installed the drivers and everything but it does not recognize the help modems please

 

[Daddy_phill0201]

The newest version should be ok, you might just need the right script to get it going... I was having the Dammn same problem.

 

[BebokingPR]

Hello Daddy_phill0201 thanks for your input but I install the program Flashcatusb Compilation 572 Ability in the program What is the firmware I must install on the board That in the options I must mark the board the voltage is at 5V and look at 1 and 2 is fine and in the program looks frame Options I connect my SB5100 and SB5101 and does not detect what exactly to do

 

[ricktendo]

Problem 1 you are using the IDC cable, do not use this cable as the JTAG pinout is non standard.
Problem 2 in the latest software the script still needs to be updated
Problem 3 the FCUSB classic will have JTAG removed in future versions

Solution is to use an older version of the software, you will need to find which version.

 

[xuhue]

SB6121 with MX25L6445EMI-10G flash - not supported

I have the SB6121 with the flash chip MX25L6445EMI-10G and the Blackcat USB 1.8 board running in SPI mode with Enable JTAG VCC turned on, jumper set to 3.3v, and the BCUSB.3.01.SPI firmware. Pinouts connected as described in many places with Blackcat USB Pin 1 (3.3vcc) connected to the flash...

www.blackcatusb.net