• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

FlashCatUSB only work with SPI flash...

lamp

lamp

Member
.

My interface don't receive other firmware - only FCUSB.3.05.SPI.hex.

I reset the interface (key 1 ON, key 2 OFF), the sw indicate DFU,
I load new firmware (FCUSB.7.05.EJTAG_16K.hex), "Program" +
"Start application". The result is, always: DEVICE MODE: SPI...

My BCUSP is damaged?

Thanks.

.
 
Could be damaged , my advice is contact the person you bought it from and ask them for a replacement
 
.

D3m0n said:
contact the person you bought
Click to expand...

No problem.
It's good for SPI mode.

I'll buy other.

I thought someone had a
method to give a full reset
or something that could put
it to work normally ...

.

 
You could try to reflow the chip , i found on one of the adapters that i have that has solved a similar issue.
 
Basically it is a matter of applying some heat to the chip on the board to re-flow the solder joints. Not too much heat though as you could burn the chip.
 
I have this exact same problem with my BC, it worked a month or so ago for ejtag, tried to flash it tonight in dfu mode, no go, only spi is working.
 
Did anyone come up with a solution to this? It's like the device doesn't respond to programming at all...
 
The one FCUSB i have here had an issue similar to this , i solved it by reflowing the chip , but it seems it does not work on all . But it is cheap components on the FCUSB so it is possably a failure elsewhere at times.
 
.

It would be important a the manufacturer manifest ...
This is a cheap product (compared to USBJTAGNT),
however if spoiling with radidez ends up being more expensive ...

.
 
I'm thinking there has to be a cheap cap or resistor inline, im going to reflow it but my board is a 1.8 and has a coating over the entire thing. I should've just ordered a usbjtagnt off the bat, but I like the idea of not having to pay too much for technology...
 
Uma Solução Facil Também, é tentar outros softwares nas versões mais antigas como USB Black Cat 275 ou a Versão 330, Uma Dica Aqui Resolveu !!!
 
You must log in or register to reply here.
Back
Top