• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

forceware flashing to the sb6141

b0b

New Member
i am very close to flashing forceware onto the sb6141-the komodo script is working and i can backup and write w/o problems-i have backed up uboot, env, nvram and everything else now i just need to know the procedure for flashing.-i have forceware version 1.4b1-mod2-its a 3.2 mb file-do i flash in full flash?-also tried flashing in ubfi and ufbi2 no luck could use just a little more help-thanks
 
Flash forceware to ubfi1 and 2 (pay attention to the size of the bin that its not 8MB, if it is then this is a full flash dump)
 
thank you so much for your help-i flashed firmware from the mybb site-it is a 3.328 file and it installed fine-i also have another file from the hackaday io site and it is 3.2mb has anyone used any of these before??-i am getting real close here=all lights are good and online solid green, also forceware reads online but no internet. can i get a config file from a working forceware modem? (how)-thanks again!
 
There is no need to install to UBFI2 only UBFI1 flash it from 0x40000 on down
 
Can somebody please share the komodo script I had it but it was lost with my melting m.2 drive
 
Back
Top