• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

issues with 1.8 board holding firmware

jason

Member
i noticed this tonight 1.8 bcusb 304 after firmware loaded.PNG it would not let me install it on 3.04. my computer also acted sluggish and didnt want to close the 3.04 after i disconnected the bcusb.

i then opened a older version and installed the firmware. build 271 and installed avr 6.01.1.8 BCUSB 271 firmware loaded.PNG

i then opened build 3.04 again and got 1.8 bcusb 304 after firmware loaded.PNG
notice it says windows 32 bit? i am windows 7 64 bit. i am not sure if that matters, just making sure you notice that. the 1.7 i have works fine in build 271 but not 3.041.7 bcusb 3.04.PNG

1.7 bcusb after fireware 6.01 installed.PNG
and i get this after installing 6.01 avr on the 1.7 and opeing it in the 3.04.
i have downloaded 3.04 a few times to make sure it was clean. i see it as a issue on my laptop but can anyone figure it out?
 
You will get this error as the old 6.01/6.03 firmware was not designed to work with the newer build 300+. For the latest build 300 + you MUST use firmware version 7.02 (16k) or 7.04 (32k) , also you cannot use the firmware 7X version on older bcusb builds.

As for the 32bit showing , do not worry too much about that , it is just a small issue in the software compiling , it will not affect the software at all
 
beautiful . thanks again for the help. i am glad you know these things as good as you do lol
 
Back
Top