• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

m28w160 connecting

S

sirszor

New Member
I would like to read and program an ST m28w160 flash.
What firmware should I use for this?
What is the correct pin connections for this? Unfortunately in datasheet of of this device I cant find similar pin names what are in the programmer manual.
The chip pin names in datasheet: a0-a19, DQ0-DQ15, E, G, W, RP, WP, Vdd, Vddq, Vpp, Vss
In manual of programmer there are this Pin names: TCK, TMS, TD0, TDI, TRST, GND or GND, Vcc, SI, SO, SCLK, RST, CS, PROG
Thank you for help!
 
This programmer will not connect direct to this chip , you would need a totally different programmer to do that.
Does your chip not have a EJTAG pin header on the device it is connected to ??
 
But there is in supported device list the 28w160cb chip. The datasheet was wrong what I saw?
 
It is a supported chip , when connected to a device that will allow you to read/write to it .
It is not supported as a stand alone programmable chip.
 
Sorry, but I dont understand... What device do you think what can allow to read and write it?
If the target board has JTAG port, possible to read it?
 
Is your chip connected to a device such as a modem or a router (that is not ARMbased) ? If yes and it has a jtag header that you can connect to then it is possable to read/write to this chip.
But if you just have the chip itself then you need a totally different programmer to program it something like this http://www.sivava.com/ would program a standalone TSOP48
 
Thank you. I understand. Yes it is on a target board (wehicle dashboard). I will check type of CPU.
 
You must log in or register to reply here.
Back
Top