• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

mx25l6406emi detected but not in flash library

b0b

New Member
hello
i ran into this problem today-did i miss something?-if not could this chip be added? -thank-you

MXIC8130883
MX25L6406EMI-126-3N310600
 

Attachments

  • MX[1].jpg
    MX[1].jpg
    5.6 MB · Views: 26
What version pcb is your fcusb, how are you connecting to the spi chip?
What version pcb is your fcusb, how are you connecting to the spi chip?
its 2.2 but i think problem is in fcusb that was have been exposed to a coffee spill-it worked for a short time but now not recognizing anything or "not in library" so i have ordered a new unit-hopefully this fixes the problem, thanks for your reply.
 
its 2.2 but i think problem is in fcusb that was have been exposed to a coffee spill-it worked for a short time but now not recognizing anything or "not in library" so i have ordered a new unit-hopefully this fixes the problem, thanks for your reply.
ok-i got the new unit today hooked it up and triple check the connections and still no flash detected on spi. i cannot figure it out. device is recognized by windows ok, no driver problems, brand new 5252 clip, new fcusb. wtfo?Fcusb_hookup[1].jpg
 
I have come across SPI flashes that you connect your pomona clip to and it is detected every time, I have also come across others that are hard to detect, you have to play with the pomona clip quite a bit to get it to detect.
 
ok-i got the new unit today hooked it up and triple check the connections and still no flash detected on spi. i cannot figure it out. device is recognized by windows ok, no driver problems, brand new 5252 clip, new fcusb. wtfo?View attachment 1243

it looks well connected, it must be set to 3.3v fcusb ... to detect it you must plug / unplug 12v of the cable modem for only 1 second without disconnecting Fcusb + pomona and detecting F1 again
 
ok-i got the new unit today hooked it up and triple check the connections and still no flash detected on spi. i cannot figure it out. device is recognized by windows ok, no driver problems, brand new 5252 clip, new fcusb. wtfo?View attachment 1243
 
If that is a 6141 I have tried a trick where while connected, I have connected the standard 12 V power cord to the modem for less than a second and unplugged it right away. Then attempt to detect. Mind you this is while the programmer is connected. I have done this with my blackcat usb, my usbjtagnt, and my xport. they have all worked with that trick.
 
Back
Top