Here is an official release from the developer
Full SVF (and XSVF) file format support has been added to BETA 315. This allows programming of many FPGA and CPLD devices, such as the Xilinx Coolrunner chips (XC2C64A etc). In addition, the new JTAG firmware allows you to enable a VCC pin (adjacent to TMS) that can be used to power an additional device, such as the chip you are trying to program (5v or 3.3v, up to 100ma).
http://www.embeddedcomputers.net/products/BlackcatUSB/
There is an added Jtag_VCC pin that can be enabled to produce the 3.3v needed to power the CPLD.
See attached pic.
Also a couple of shots of a TX Coolrunner with the added screenshot of the BCUSB software detecting the device.
This is a Beta Release , so if any bugs are found ,please report them in the BUGS section of the forum
Full SVF (and XSVF) file format support has been added to BETA 315. This allows programming of many FPGA and CPLD devices, such as the Xilinx Coolrunner chips (XC2C64A etc). In addition, the new JTAG firmware allows you to enable a VCC pin (adjacent to TMS) that can be used to power an additional device, such as the chip you are trying to program (5v or 3.3v, up to 100ma).
http://www.embeddedcomputers.net/products/BlackcatUSB/
There is an added Jtag_VCC pin that can be enabled to produce the 3.3v needed to power the CPLD.
See attached pic.
Also a couple of shots of a TX Coolrunner with the added screenshot of the BCUSB software detecting the device.
This is a Beta Release , so if any bugs are found ,please report them in the BUGS section of the forum