• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

Request for Dish 301-010 Sat.Receiver

It should be possable , connect up your BCUSB in ejtag mode and see what ouput you get .
 
Connected to Device: 36 4000
From Console Logs..
LibUsbDotNet version: 2.2.8.104
BlackcatUSB Script Engine running, build: 150
Welcome to Blackcat USB interfacing software, build: 271
Running on: Microsoft Windows 7 Ultimate (64 bit)
Initializing EJTAG engine
Device connected in JTAG mode: 6.03
Engine setup successfully
Detected CPU ID: 0x5400006D IMP CODE: 0x1B71700
Manufacturer ID: 0x36 Part ID: 0x4000
EJTAG Version support: 2.0
Target device supports DMA mode
Checking for a device specific script
Loading script: default.bcs
Setting device parameter (AMD Flash delay) to 0xFA
Setting device parameter (Memory Read Delay) to 0xFA
Beginning memory read from DRAM
Start address: 0 (0x00) Length: 8388608
Read operation complete
8388608 bytes read in 170.217 seconds, 49,282 Bytes/s
 
Did it not see the flash on the device ?? a few screenshots would be good
 
Thanks ,, looking at this it has not correctly identified certain aspects of the device. I will have a word with the developer and see if this CPU is supported . As we are getting a partial detection , it should not be too difficult to add the device.
The developer may be able to get hold of one of these devices as he is from the states.
 
Thank you so much..

BTW, I've used blackcat for flashing DPC3000. It works perfectly.
 
Can you try this command in the console window and tell me what you get :

JTAG.FlashFind()
 
Still looking into this , unfortunately i have to wait on a response from the developer before i can give you an appropriate reply .
 
You must log in or register to reply here.
Back
Top