Hi guys
New to this forum. I tried other forums but it takes weeks before someone respond there. I hope this is better place .
I bought Motorola SB5101 and flashcat. Soldered 10 pins to modem board and connected to flashcat with gray 10 pin cable that came with it. Installed driver and flashcat shows in device manager. Start it and it says:
FlashcatUSB status: Connected
Device mode: Serial Programmable Interface (SPI)
Board firmware version: 4.06
Connected to device: (no flash detected)
I tried to connect the cable in many different ways but still nothing. What am I doing wrong?
New to this forum. I tried other forums but it takes weeks before someone respond there. I hope this is better place .
I bought Motorola SB5101 and flashcat. Soldered 10 pins to modem board and connected to flashcat with gray 10 pin cable that came with it. Installed driver and flashcat shows in device manager. Start it and it says:
FlashcatUSB status: Connected
Device mode: Serial Programmable Interface (SPI)
Board firmware version: 4.06
Connected to device: (no flash detected)
I tried to connect the cable in many different ways but still nothing. What am I doing wrong?