• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

SB5101 flash not detected

That does not make sense ??? the JTAG VCC pin was for something else , so do you have hax installed now ?
 
Yes. I was able to do it after I enabled the pin. Unless something else changed in the meantime. But it did worked after I enable it.
 
hmm weird ,, ahh well at least you have it loaded now so all good ...
 
[QUOTE = "D3m0n, postagem: 3210, membro: 1"]
Ok think i see the problem that diagram of the 5101 pinouts is incorrect ....
On the modem

pin 1 = TRST goes to pin 1 fcusb
pin 3 = TDI goes to pin 3 fcusb
pin 5 = TDO goes to pin 5 fcusb
pin 7 = TMS goes to pin 7 fcusb
pin 9 = TCK goes to pin 2 fcusb

then connect GND pin 10 on fcusb

So in your post #5 follow the number sequence with these to connect to your FCUSB board

[/ CITAR]


Hello I need your help, what is the pinout for SB5101 using FlashcatUSB Professional to read Jtag?
 
Ok think i see the problem that diagram of the 5101 pinouts is incorrect ....
On the modem

pin 1 = TRST goes to pin 1 fcusb
pin 3 = TDI goes to pin 3 fcusb
pin 5 = TDO goes to pin 5 fcusb
pin 7 = TMS goes to pin 7 fcusb
pin 9 = TCK goes to pin 2 fcusb

then connect GND pin 10 on fcusb

So in your post #5 follow the number sequence with these to connect to your FCUSB board



good morning friend is the same connection scheme for the blackcat v1.8 usb? thank you very much. should I leave it at 3.3 or 5 v ??
 
do we have bsdl's for the bcm3349 and or updated scripts? Is there a way to update the scripts or a way we can with the updated software?
 
Back
Top