• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

Toshiba TC58NVG2S0HTA00

zeeshan

New Member
my nand is toshiba TC58NVG2S0HTA00 and this nand is not write correctly in FlashcatUSB xPort please any one help me any suggestion
 
Last edited:
I connect wire between this 2 pins but not write original file in nand I compare flash to original save file see picture
 

Attachments

  • BEFB8A9F-033A-4D7C-BA86-26F82F7FA4F0.png
    BEFB8A9F-033A-4D7C-BA86-26F82F7FA4F0.png
    638.6 KB · Views: 77
  • 8D3BE691-4B62-4DD2-99EE-48D86621B860.png
    8D3BE691-4B62-4DD2-99EE-48D86621B860.png
    633.4 KB · Views: 71
I also did the correction, but when I compare never matches... (55%, 60%, 76%) can anyone explain or help?
 
yes you say right i have same problem never compare matches 67%,56%

During the reading, I make a comparison with the created file and it always shows 99%, never 100%, will be normal considering the type of memory?
 
the same... 55/66% ... any idea what it might be?

no idea friend , any master here see our problem and help please and may be tsop-48 problem one they find wp pin vcc may be anoter pin has not connect with xport
 
Last edited:
Hi.
I have a new project, copy the information from a Toshiba flash tc58nvg0s3htai0 installed on a motherboard of an Arris modem, and copy it into a new one.

I have to buy the FlashcatUSB xPort, and I would like you to detail me all the adapters that I need, there are many different ones and I need help to select the right.

Thank you.
 
hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
 
hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
That has nothing to do with Mach1 or any other programmer, if you check your 360 clip is smallest than the TC58 chip if you reduce a little bit not to much the 360 clip to make the TC58 to inter freely and push a little be forward the 360 clips contacts with a needle then you are good.
 
hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
Where did u get the pinout to match the xport with the 360clip?
 
Back
Top