yes you say right i have same problem never compare matches 67%,56%
first i copy master nand and compare with save file its 99% match and if write this file is bad flash and compare 66%
the same... 55/66% ... any idea what it might be?
adami,
which nand you read in this flashcat?
That has nothing to do with Mach1 or any other programmer, if you check your 360 clip is smallest than the TC58 chip if you reduce a little bit not to much the 360 clip to make the TC58 to inter freely and push a little be forward the 360 clips contacts with a needle then you are good.hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
Where did u get the pinout to match the xport with the 360clip?hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba