• Seems like hotmail /outlook is blocking emails from here so please refrain from using one of these accounts as you may not receive your authorization email.. many thanks

Unable to detect compatible SPI device

strich

New Member
Hi,

When I run the following command line:
"FlashcatUSB.exe -write -spi -file MAIN_SB2_P4_NOR.bin"

I get the following output. It says it could not detect a compatible SPI device.

Welcome to the FlashcatUSB interfacing software, Build: 570
Copyright 2019 - Embedded Computers LLC
Running on: Microsoft Windows 10 Pro (64 bit)
Successfully connected to FlashcatUSB over USB
Board firmware version: 4.41
Device mode: Serial Programmable Interface (SPI-NOR)
Unable to detect compatible SPI device
Flash memory not detected on SPI NOR mode
----------------------------------------------
Press any key to close

When I launch the application manually, the SPI detects after ~0.5 seconds.

I can flash my device manually no problem. Is there a way to make the command line argument wait ~5 seconds to detect the SPI device before it timesout?

Additional Info:
Build 570
 

strich

New Member
I'm starting to think the issue is more than following line "Flash memory not detected on SPI NOR mode"
 

strich

New Member
This is norflashing manually. I would like to do it via command line. ( Just adding more information)

1234
 

strich

New Member
Alright... I think I solved it... I had two (2) Flashcat's connected to my computer. For some reason, when I ran the application manually, it worked. but through the command prompt, it doesn't like having 2 flash cat devices connected.
 
Top