• Seems like hotmail /outlook is blocking emails from here so please refrain from using one of these accounts as you may not receive your authorization email.. many thanks

Fail to verify

Barak1

New Member
Hey

I got a flashcat usb, I've been playing with my modded dpc2100 and netgear modems. My DPC2100 has been dead and doesnt give my computer an IP nor can I access the default haxorware page. With the netgear modem, I was able to access haxorware but when I tried to flash haxorware through flashcat software, it gave me an error that it was unable to verify the flash, it then asked if I wanted to proceed or not. I found the check box for verifying and disabled it. I was able to flash the firmware but when I rebooted the modem, it turned out dead like the DPC2100, no haxorware page at 192.168.100.1

I've noticed when I connect the modems with flashcat jtag, the last tab doesnt say the modem model, it just specifies the broadcom chip... 3349...

I noticed the script it loads is 3349... should I be loading a different script? Am I missing a step? help?
 

D3m0n

Administrator
Staff member
There were changes made to the scripts that stopped certain functions from working as they did previously.
What version of fcusb hardware do you have and what version of software are you using ?
Also post a screenshot of grab the console log from the fcusb software and post it here please.
 

Barak1

New Member
The script that the original software would default to was 3349...

After copying scripts from older BC software the script for dpc2100 couldn't be seen by the new FC software. It would then default to sb5101..

Issue was unchanged no matter which script was used.
 

D3m0n

Administrator
Staff member
Try loading this script , the old ones you are using are .bcs , the new ones are .fcs .
 

Attachments

Barak1

New Member
Still failing to verify but I also noticed a msg that said something to the effect of, no cfg area found
 
Top