Damn-Deal-Done
New Member
Hello.
I bought a FlashcatUSB Xport from Embedded Computers for the specific reason of burning MX29F1610MC-10 and MX29F1610A chips. I was told it does program these chips which prompted me to make the purchase.
I am using the SOP-44 adapter with the three switches.
I have successfully written a MX29LV160TMC-90 with setting Power to 3V. Pin 1 to RB. Pin 43 to A19. Pin 44 to WE.
For the MX29F1610 I set the Power to 5V. Pin 1 to WE. Pin 43 to A19. Pin 44 to VPP. However on the datasheet Pin 44 is WP so I am not sure what to do here.
I get the message "Flash memory detected but not found in flash library".
Log is as follows.
Can anyone offer me some help?
Many thanks
I bought a FlashcatUSB Xport from Embedded Computers for the specific reason of burning MX29F1610MC-10 and MX29F1610A chips. I was told it does program these chips which prompted me to make the purchase.
I am using the SOP-44 adapter with the three switches.
I have successfully written a MX29LV160TMC-90 with setting Power to 3V. Pin 1 to RB. Pin 43 to A19. Pin 44 to WE.
For the MX29F1610 I set the Power to 5V. Pin 1 to WE. Pin 43 to A19. Pin 44 to VPP. However on the datasheet Pin 44 is WP so I am not sure what to do here.
I get the message "Flash memory detected but not found in flash library".
Log is as follows.
Code:
Connected to FlashcatUSB XPORT, firmware version: 5.16
Firmware features supported: SPI, I2C, EXTIO
Initializing Parallel mode
Parallel mode successfully initialized
Attempting to automatically detect Flash device
Mode NAND X8 ASYNC returned ident code: 0x0707070707
Mode NOR X16 (Word addressing) returned ident code: 0xC200F80000
Mode NOR X16 (Byte addressing) returned ident code: 0xC20000C200
Connected to Flash (CHIP ID: 0xC20000C200)
Common Flash Interface information not present
For device support email ****@**** with the DEVICE ID
Can anyone offer me some help?
Many thanks
Last edited: