Trying to flash my wrt54gs 7 could use help

[jb_bak]

I can't seem to get a connection.

it's a 12 port. What do I connect the nSrst to on the blackcat?

http://wiki.openwrt.org/_detail/old...4gl_v11_jtagport___.jpg?id=toh:linksys:wrt54g

Using firmware version 7.05 on the blackcat. Keep getting error connecting.

 

[jb_bak]

I just need one ground connected right? The standard cable doesn't seem to connect up right.

 

[D3m0n]

Reset is not needed , the standard cable should be fine , once turned around

 

[jb_bak]

thanks for the quick reply. i've tried both ways. i'm using the 10 pins closest to the corner. so no nSrst and grd pin
here is a quick vid

 

[D3m0n]

In your video , the cable is connected the correct way. But there is not even a BCM detection , was the pin header in place or did you solder it on ?

 

[jb_bak]

I soldered it in. I checked all connections for with ohm meter. This is a bricked wrt.

 

[D3m0n]

BCUSB is not the best tool for debricking , but even if a device was bricked it should still see the BCM on the device. Try putting some force on the pin header , slightly pushing it at an angle to see if you can get a detection.

 

[jb_bak]

[IMG=http://img542.imageshack.us/img542/5039/photo2pc.jpg][/IMG]

Nah didn't seem to help. I have the 10pin header in the right spot right?

 

[D3m0n]

Pin header is in the correct spot , tell me when you power on the router do you get any LED's at all or is it completely dead ?