Xilinx XC95288XL

[obitus1990]

Hello,

I am trying to program the CPLD above via JTAG mode. I have the wires connected properly on both the programmer and the board in question.

However, I get the following upon connection to Build 624 (and in the JTAG tab, it identifies the CPLD as a Xilinx 0x9616):

FlashcatUSB Script Engine build: 310
Welcome to the FlashcatUSB interfacing software, build: 624
Running on: Microsoft Windows 10 Home (64 bit)
Serial NOR memory database loaded: 478 devices supported
Serial NAND database loaded: 0 devices supported
Parallel NOR memory database loaded: 365 devices supported
Parallel NAND memory database loaded: 295 devices supported
OTP/UV EPROM memory database loaded: 41 devices supported
Connected to FlashcatUSB Classic, firmware version: 4.53
JTAG TCK speed: 1 MHz
JTAG chain detected: 1 devices
JTAG TDI IR chain size: 8 bits
Index 0: JEDEC ID 0x59616093 - BSDL definition not found
JTAG engine setup successfully
JTAG chain is not valid, not all devices have BSDL loaded


What do I need to do? I have the .svf to program it, but cannot proceed further.

Thank you!