So I'm new to using a Flashcat but I can't seem to get mine to detect it being connect to a Spansion PFL064PIF. I have it connected via some wires and test clips, I tested the ground and VCC and detected I was getting a 3.3v signal.
I tried to unplug and plug back in the Flashcat. I've also attempted with the DIP switches (1 and 2, not the power settings) set in all different settings. Non have produce the detection of the chip.
What am I missing?
I tried to unplug and plug back in the Flashcat. I've also attempted with the DIP switches (1 and 2, not the power settings) set in all different settings. Non have produce the detection of the chip.
What am I missing?