• Seems like hotmail /outlook is blocking emails from here so please refrain from using one of these accounts as you may not receive your authorization email.. many thanks

Problem with NAND devices on XPort

regiskzm

New Member
Hello,

Recently I got an FCUSB xPort and a TSOP 48 adapter for NAND and NOR devices.

NOR devices are running Ok but for NAND, xPort recognize device but can't read it (just appears 00 on Flash Tab).

1578938232070.png

I tried others NAND devices manufcatures (Zentel, Toshiba, ESMT, Spansion) and they working same way.
And when I re-initialize (F1 button), xPort stuck and I need reset it.

Can someone help me?
 

jack2000

New Member
Hi to all in the Forum, I also have the same problem with the xport and nand adapter. This is my console mesage, I have no idea if this is a problem with this memory or the Flashcat. Thanks with any help.
Console.jpg
 

jack2000

New Member
Ok, looks nobody going to answer, time to look for another kind of programmer, spend money on this blackcat for nothing and no support from them.
 

regiskzm

New Member
Hi jack200,

You need go on "Protocol Settings", and on NAND tab, select Separate or Segmented on Main/spare area layout field.
After this, the field above (Bad block manager) can be selected enabled.

1579516829873.png

So that message on console tab disappears.
 

jack2000

New Member
Thanks for the help, but I have the same problem like you have. Under NAND X8 Flash, I have all 0, I'm trying with other Flash Chip and the same result. Also I need to reset the programmer every time I redetect. Do you ever find a solution for that? Thanks
 
Last edited:

regiskzm

New Member
I have exactly the same problem, all 0s on any Flash Chips I've tested. But I did'nt find a solution yet.
 

jack2000

New Member
Ok, after many tried I decided to buy a decent programmer with many adapters and stop trying with this one. Even with the new software release I had the same result. NOT recommended.
 
Top