• Seems like hotmail /outlook is blocking emails from here so please refrain from using one of these accounts as you may not receive your authorization email.. many thanks

SB5101 flash not detected

D3m0n

Administrator
Staff member
That does not make sense ??? the JTAG VCC pin was for something else , so do you have hax installed now ?
 

Kris

Member
Yes. I was able to do it after I enabled the pin. Unless something else changed in the meantime. But it did worked after I enable it.
 

D3m0n

Administrator
Staff member
hmm weird ,, ahh well at least you have it loaded now so all good ...
 

Gus

New Member
[QUOTE = "D3m0n, postagem: 3210, membro: 1"]
Ok think i see the problem that diagram of the 5101 pinouts is incorrect ....
On the modem

pin 1 = TRST goes to pin 1 fcusb
pin 3 = TDI goes to pin 3 fcusb
pin 5 = TDO goes to pin 5 fcusb
pin 7 = TMS goes to pin 7 fcusb
pin 9 = TCK goes to pin 2 fcusb

then connect GND pin 10 on fcusb

So in your post #5 follow the number sequence with these to connect to your FCUSB board

[/ CITAR]


Hello I need your help, what is the pinout for SB5101 using FlashcatUSB Professional to read Jtag?
 

Brunozuca

New Member
Ok think i see the problem that diagram of the 5101 pinouts is incorrect ....
On the modem

pin 1 = TRST goes to pin 1 fcusb
pin 3 = TDI goes to pin 3 fcusb
pin 5 = TDO goes to pin 5 fcusb
pin 7 = TMS goes to pin 7 fcusb
pin 9 = TCK goes to pin 2 fcusb

then connect GND pin 10 on fcusb

So in your post #5 follow the number sequence with these to connect to your FCUSB board


good morning friend is the same connection scheme for the blackcat v1.8 usb? thank you very much. should I leave it at 3.3 or 5 v ??
 
Top